Section 37.03.03.001 - TITLE AND SCOPE01.Title. These rules are titled IDAPA 37.03.03 "Rules and Minimum Standards for the Construction and Use of Injection Wells."02.Scope. These rules and minimum standards are for construction and use of injection wells in the state of Idaho. Upon promulgation, these rules apply to all injection wells (see Rule Subsection 035.01). The construction and use of Class I, III, IV, or VI injection wells are prohibited by these rules. Class IV wells are also prohibited by federal law. These rules and minimum standards for construction and use of injection wells apply to all injection wells in the state of Idaho, except in Indian lands. All injection wells shall be permitted and constructed in accordance with the "Well Construction Standards Rules" found in IDAPA 37.03.09 which are authorized under Section 42-238, Idaho Code.03.Rule Coverage. In the event that a portion of these rules is less stringent than the minimum requirements for injection wells as established by Federal regulations, the correlative Federal requirement will be used to regulate the injection well.04.Variance of Methods. The Director may approve the use of a different testing method or technology if it is no less protective of human health and the environment, will not allow the migration of injected fluids into a USDW, meets the intent of the rule, and yields information or data consistent with the original method or technology required. A request for review by the Director must be submitted in writing by the applicant, permit holder, or operator and be included with all pertinent information necessary for the Director to evaluate the proposed testing method or technology.Idaho Admin. Code r. 37.03.03.001