Section 20.03.16.055 - OPERATIONS UNDER THE LEASE01.Best Practices. The lessee will at all times conduct exploration, development, drilling and all operations as a reasonably prudent operator and conform to the best practice and engineering principles in use in the oil and gas industry.02.Compliance with Rules. The lessee will comply with all rules of the oil and gas commission, including amendments promulgated pursuant to Title 67, Chapter 52, Idaho Code, and any violations of the commission's rules or other applicable state laws and rules may constitute a violation of the lease under these rules.03.Designation of Operator. In all cases where operations are not conducted by the lessee but are to be conducted under authority of an approved operating agreement, assignment or other arrangement, a designation of operator must be submitted to the Director prior to commencement of operations. Such a designation authorizes the operator or his local representative to act for the lessee and to sign any papers or reports required under these rules. The lessee must immediately report to the Director all changes of address and termination of the authority of the operator.04.Legal Representative. When required by the Director, the lessee must designate a local representative empowered to receive service of civil or criminal process and notices and orders of the Director issued pursuant to these rules.05.Diligence. The lessee will, subject to the right to surrender the lease, diligently drill and produce such wells as are necessary to protect the Board from loss by reason of production on other properties, or with the consent of the Director, compensate the Board for failure to drill and produce any such well. All wells under lease must be drilled, maintained and operated to produce the maximum amount of oil and/or gas that can be secured without injury to the well.06.Loss Through Waste or Failure to Produce. The Director will determine the value of production accruing to the Board where there is loss through waste or failure to drill and produce protection wells on the leased lands and the compensation due to the Board as reimbursement for such loss. Payment for such losses must be made within sixty (60) days after the date of billing. The value of production resulting from a loss through waste or failure to take corrective measures to protect a well is calculated at ninety percent (90%) of the last year's actual production royalty or a minimum royalty of five dollars ($5) per acre or fraction thereof, whichever is greater.07.By-Products. Where production, use of conversion of oil and gas under a lease, is susceptible of producing a valuable by-product or by-products, including, without limitation, commercially demineralized water, carbon dioxide or helium, the lessee must submit to the Director all available information concerning the potential by-product. The Department may conduct tests or studies at its expense and may issue reasonable orders to produce and preserve such by-product.08.Geothermal Information. Prior to abandoning any well, the lessee must submit to the Director all available information concerning geothermal resource potential. The Department may conduct tests or studies at its expense prior to the abandoning of any well to determine geothermal resource potential. Except as provided in Subsection 040.05, the lessee must promptly plug and abandon any well on the leased land that is not used or useful, in accord with these rules and the rules of the commission, and any applicable rules and regulations of the Department of Water Resources. When drilling in a known geothermal resources area, the applicant may need a geothermal resource well permit from the Department of Water Resources.Idaho Admin. Code r. 20.03.16.055