FIGURE K § 901: ILLUSTRATION OF BOUNDARIES OF THE WR-1 ZONE
The WR-1 zone is intended to
The development standards for the WR-1 zone are set forth in the following table:
TABLE K § 901.2: WR-1 DEVELOPMENT STANDARDS
WR-1 | |||||||
Sub-Area (Land Bays A.1, B and C) | Lot Width (min.) | Building Height (max.) | Stories (max.) | Lot Occupancy (max.) | Pervious Surface (min.) | Side Yard (min.) | Rear Yard (min.) |
Lots with any frontage on Fern Street | 18 ft. | 45 ft. | 4 | 70% | 10% | None required; 4 ft. if provided | None required |
Any other lot | 18 ft. | 55 ft. | 5 | 70% | 10% | None required; 4 ft. if provided | None required |
The maximum number of permitted dwelling units on any lot shall be two (2), which includes both principal and accessory units.
For any inclusionary or affordable residential unit that is administered through the Department of Housing and Community Development, the minimum lot width shall be sixteen feet (16 ft.).
Height shall be measured in accordance with Subtitle B §§ 308, except that for any building fronting on Elder Street, the building height measuring point may be established at the finished grade at the middle of the front of the building.
No building shall be located between Fern and Elder Streets within fifty feet (50 ft.) of the western boundary of the WR zone.
In the WR-1 zone, no driveway or garage entrance providing access to parking or loading areas shall be permitted from a public or private street.
In the WR-1 zone, any private driveway shall be constructed of pervious materials. This does not apply to a private alley.
An addition to a single dwelling unit or flat, or a new or enlarged accessory structure on the same lot as a single dwelling unit or flat, shall be permitted, even though the addition or accessory structure does not comply with all of the requirements of Subtitle K § 901.2, as a special exception if approved by the Board of Zoning Adjustment under Subtitle X, Chapter 9, subject to the provisions of this subsection:
D.C. Mun. Regs. tit. 11, r. 11-K901