7 Del. Admin. Code § 7103-134.0
Current through Reigster Vol. 28, No. 6, December 1, 2024
Section 7103-134.0 - Class A Sludge - Sludges processed to further reduce pathogens (PFRP)134.1 Sludges prepared to meet Class A requirements must be processed by means of one of the following alternatives. The Class A pathogen requirements in Subsection 134.1.1 through 134.1.5 shall be met either prior to meeting or at the same time the vector attraction reduction requirements in Subsection 135.0 (except for 135.6, 7, 8,) are met. 134.1.1 Class A - Alternative 1. 134.1.1.1 Either the density of fecal coliform in the sewage sludge shall be less than 1000 Most Probable Number per gram of total solids (dry weight basis), or the density of SALMonella sp. bacteria in the sewage sludge shall be less than three Most Probable Number per four grams of total solids (dry weight basis) at the time the sewage sludge is prepared for sale or give away in as bag or other container for application to the land; or at the time the sewage sludge or material derived from sewage sludge is prepared to meet the requirements in Section 700.134.1.1.2 The temperature of the sewage sludge that is used or disposed shall be maintained at a specific value for a period of time. 134.1.1.2.1 When the percent solids of the sewage sludge is seven percent or higher, the temperature of the sewage sludge shall be 50 degrees Celsius or higher; the time period shall be 20 minutes or longer; and the temperature and time period shall be determined using equation (2), except when small particles of sewage sludge are heated by either warm gases or an immiscible liquid. Where, D = time in days.
t = temperature in degrees Celsius.
134.1.1.2.2 When the percent solids of the sewage sludge is seven percent or higher and small particles of sewage sludge are heated by either warmed gases or an immiscible liquid, the temperature of the sewage sludge shall be 50 degrees Celsius or higher; the time period shall be 15 seconds or longer; and the temperature and time period shall be determined using equation 2.134.1.1.2.3 When the percent solids of the sewage sludge is less than seven percent and the time period is at least 15 seconds but less than 30 minutes, the temperature and time period shall be determined using equation (2).134.1.1.2.4 When the percent solids of the sewage sludge is less than seven percent; the temperature of the sewage sludge is 50 degrees Celsius or higher; and the time period is 30 minutes or longer, the temperature and time period shall be determined using equation (3). Where, D = time in days.
t = temperature in degrees Celsius.
134.1.2 Class A - Alternative 2. 134.1.2.1 Either the density of fecal coliform in the sewage sludge shall be less than 1000 Most Probable Number per gram of total solids (dry weight basis), or the density of Salmonella sp. bacteria in the sewage sludge shall be less than three Most Probable Number per four grams of total solids (dry weight basis) at the time the sewage sludge is used or disposed; at the time the sewage sludge is prepared for sale or give away in a bag or other container for application to the land; or at the time the sewage sludge or material derived from sewage sludge is prepared to meet the requirements in Section 700.134.1.2.2134.1.2.2.1 The pH of the sewage sludge that is used or disposed shall be raised to above 12 and shall remain above 12 for 72 hours.134.1.2.2.2 The temperature of the sewage sludge shall be above 52 degrees Celsius for 12 hours or longer during the period that the pH of the sewage sludge is above 12.134.1.2.2.3 At the end of the 72 hour period during which the pH of the sewage sludge is above 12, the sewage sludge shall be air dried to achieve a percent solids in the sewage sludge greater than 50 percent.134.1.3 Class A - Alternative 3. 134.1.3.1 Either the density of fecal coliform in the sewage sludge shall be less than 1000 Most Probable Number per gram of total solids (dry weight basis), or the density of Salmonella sp. bacteria in sewage sludge shall be less than three Most Probable Number per four grams of total solids (dry weight basis) at the time the sewage sludge is used or disposed; at the time the sewage sludge is prepared for sale or give away in a bag or other container for application to the land; or at the time the sewage sludge is prepared to meet the requirements of Section 700. 134.1.3.2 The sewage sludge shall be analyzed prior to pathogen treatment to determine whether the sewage sludge contains enteric viruses.134.1.3.2.2 When the density of enteric viruses in the sewage sludge prior to pathogen treatment is less than one Plaque-forming Unit per four grams of total solids (dry weight basis), the sewage sludge is Class A with respect to enteric viruses until the next monitoring episode for the sewage sludge.134.1.3.2.3 When the density of enteric viruses in the sewage sludge prior to pathogen treatment is equal to or greater than one Plaque-forming Unit per four grams of total solids (dry weight basis), the sewage sludge is Class A with respect to enteric viruses when the density of enteric viruses in the sewage sludge after pathogen treatment is less than one Plaque-forming Unit per four grams of total solids (dry weight basis) and when the values or ranges of values for the operating parameters for the pathogen treatment process that produces the sewage sludge that meets the enteric virus density requirement are documented.134.1.3.2.4 After the entric virus reduction in paragraph 134.1.3.2.3of this section is demonstrated for the pathogen treatment process, the sewage sludge continues to be Class A with respect to enteric viruses when the values for the pathogen treatment process operating parameters are consistent with the values or ranges of values documented in paragraph 134.1.3.2 of this section.134.1.3.3134.1.3.3.1 The sewage sludge shall be analyzed prior to pathogen treatment to determine whether the sewage sludge contains viable helminth ova.134.1.3.3.2 When the density of viable helminth ova in the sewage sludge prior to pathogen treatment is less than one per four grams of total solids (dry weight basis), the sewage sludge is Class A with respect to viable helminth ova until the next monitoring episode for the sewage sludge.134.1.3.3.3 When the density of viable helminth ova in the sewage sludge prior to pathogen treatment is equal to or greater than one per four grams of total solids (dry weight basis), the sewage sludge is Class A with respect to viable helminth ova when the density of viable helminth ova in the sewage sludge after pathogen treatment is less than one per four grams of total solids (dry weight basis) and when the values or ranges of values for the operating parameters for the pathogen treatment process that produces the sewage sludge that meets the viable helminth ova density requirement are documented.134.1.3.3.4 After the viable helminth ova reduction in 134.1.3.2.3 of this subsection is demonstrated for the pathogen treatment process, the sewage sludge continues to be Class A with respect to viable helminth ova when the values for the pathogen treatment process operating parameters are consistent with the values or ranges of values documented in 134.1.3.2.3 of this subsection.134.1.4 Class A - Alternative 4. 134.1.4.1 Either the density of fecal coliform in the sewage sludge shall be less than 1000 Most Probable Number per gram of total solids (dry weight basis), or the density of Salmonella sp. bacteria in the sewage sludge shall be less than three Most Probable Number per four grams of total solids (dry weight basis) at the time the sewage sludge is used or disposed; at the time the sewage sludge is prepared for sale or give away in a bag or other container for application to the land; or at the time the sewage sludge or material derived from sewage sludge is prepared to meet the requirements in Section 700.134.1.4.2 The density of enteric viruses in the sewage sludge shall be less than one Plaque-forming Unit per four grams of total solids (dry weight basis) at the time the sewage sludge is used or disposed; at the time the sewage sludge is prepared for sale or give away in a bag or other container for application to the land; or at the time the sewage sludge or material derived from sewage sludge is prepared to meet the requirements in Section 700 unless otherwise specified by the permitting authority.134.1.4.3 The density of viable helminth ova in the sewage sludge shall be less than one per four grams of total solids (dry weight basis) at the time the sewage sludge is used or disposed; at the time the sewage sludge is prepared for sale or give away in a bag or other container for application to the land; or at the time the sewage sludge or material derived from sewage sludge is prepared to meet the requirements in Section 700, unless otherwise specified by the permitting authority.134.1.5 Class A - Alternative 5. 134.1.5.1 Either the density of fecal coliform in the sewage sludge shall be less than 1000 Most Probable Number per gram of total solids (dry weight basis), or the density of Salmonella sp. bacteria in the sewage sludge shall be less than three Most Probable Number per four grams of total solids (dry weight basis) at the time the sewage sludge is used or disposed; at the time the sewage sludge is prepared for sale or given away in a bag or other container for application to the land; or at the time the sewage sludge or material derived from sewage sludge is prepared to meet the requirements in Section 700.134.1.5.2 Sewage sludge that is used or disposed shall be treated in one of the Processes to Further Reduce Pathogens described below:134.1.5.2.1 Composting - Using either the within-vessel composting method or the static aerated pile composting method, the temperature of the sewage sludge is maintained at 55 degrees Celsius or higher for three days.134.1.5.2.1 Using the windrow composting method, the temperature of the sewage sludge is maintained at 55 degrees or higher for 15 days or longer. During the period when the compost is maintained at 55 degrees or higher, there shall be a minimum of five turnings of the windrow.134.1.5.2.2 Heat drying - Sewage sludge is dried by direct or indirect contact with hot gases to reduce the moisture content of the sewage sludge to 10 percent or lower. Either the temperature of the sewage sludge particles exceeds 80 degrees Celsius or the wet bulb temperature of the gas in contact with the sewage sludge as the sewage sludge leaves the dryer exceeds 80 degrees Celsius.134.1.5.2.3 Heat treatment - Liquid sewage sludge is heated to a temperature of 180 degrees Celsius or higher for 30 minutes.134.1.5.2.4 Thermophilic aerobic digestion - Liquid sewage sludge is agitated with air or oxygen to maintain aerobic conditions and the mean cell residence time of the sewage sludge is 10 days at 55 to 60 degrees Celsius.134.1.5.2.5 Beta ray irradiation - Sewage sludge is irradiated with beta rays from an accelerator at dosages of at least 1.0 megarad at room temperature (ca. 20 degrees Celsius).134.1.5.2.5 Gamma ray irradiation - Sewage sludge is irradiated with gamma rays from certain isotopes, such as Cobalt 60 and Cesium 137, at room temperature (ca. 20 degrees Celsius).134.1.5.2.6 Pasteurization - The temperature of the sewage sludge is maintained at 70 degrees Celsius or higher for 30 minutes or longer.134.1.6 Class A - Alternative 6. 134.1.6.1 Either the density of fecal coliform in the sewage sludge shall be less than 1000 Most Probable Number per gram of total solids (dry weight basis), or the density of Salmonella, sp. bacteria in the sewage sludge shall be less than three Most Probable Number per four grams of total solids (dry weight basis) at the time the sewage sludge is used or disposed; at the time the sewage sludge is prepared for sale or given away in a bag or other container for application to the land; or at the time the sewage sludge is prepared to meet the requirements in Section 700.134.1.6.2 Sewage sludge that is used or disposed shall be treated in a process that is equivalent to a Process to Further Reduce Pathogens, as determined by the permitting authority.134.1.6.3 Monitoring and Reporting. 134.1.6.3.1 Any sludge processed to further reduce pathogens must be monitored in accordance with the requirements described in the alternative used. Additional monitoring may be required by the Department as a permit condition.134.1.6.3.2 Anyone who prepares a Class A sludge must report the results of all monitoring for the processing alternative used on a form provided by the Department. The frequency of reporting shall comply with the reporting frequency described in Section 701 or as specified in the permit.7 Del. Admin. Code § 7103-134.0