2 Del. Admin. Code § 4D.28

Current through Register Vol. 28, No. 5, November 1, 2024

Section 4D.28 - Flashing Operation of Traffic Control Signals- General

Standard:

01 The light source of a flashing signal indication shall be flashed continuously at a rate of not less than 50 or more than 60 times per minute.

02 The displayed period of each flash shall be a minimum of 1/2 and a maximum of 2/3 of the total flash cycle.

03 Flashing signal indications shall comply with the requirements of other Sections of this Manual regarding visibility-limiting or positioning of conflicting signal indications, except that flashing yellow signal indications for through traffic shall not be required to be visibility-limited or positioned to minimize visual conflict for road users in separately controlled turn lanes.

04 Each traffic control signal shall be provided with an independent flasher mechanism that operates in compliance with this Section.

05 The flashing operation shall not be terminated by removal or turn off of the controller unit or of the conflict monitor (malfunction management unit) or both.

06 A manual switch, a conflict monitor (malfunction management unit) circuit, and, if appropriate, automatic means shall be provided to initiate the flashing mode.

Guidance:

06A (DE Revision) Traffic control signals on state-maintained roads should not alternate operations between flashing mode and steady (stop-and-go) mode except in unique circumstances.

Option:

07 Based on engineering study or engineering judgment, traffic control signals may be operated in the flashing mode on a scheduled basis during one or more periods of the day rather than operated continuously in the steady (stop-and-go) mode.

Support:

08 Sections 4E.06 and 4E.09 contain information regarding the operation of pedestrian signal heads and accessible pedestrian signal detector pushbutton locator tones, respectively, during flashing operation.

2 Del. Admin. Code § 4D.28