Section 571.204 - Standard No. 204; Steering control rearward displacementS1.Purpose and scope. This standard specifies requirements limiting the rearward displacement of the steering control into the passenger compartment to reduce the likelihood of chest, neck, or head injury.S2.Application. This standard applies to passenger cars and to multipurpose passenger vehicles, trucks, and buses. However, it does not apply to walk-in vans or vehicles without steering controls.S3.Definitions.Steering column means a structural housing that surrounds a steering shaft.
Steering shaft means a component that transmits steering torque from the steering wheel to the steering gear.
S4Requirements.S4.1Vehicles manufactured before September 1, 1991. When a passenger car or a truck, bus, or multipurpose passenger vehicle with a gross vehicle weight rating of 10,000 pounds or less and an unloaded vehicle weight of 4,000 pounds or less is tested under the conditions of S5 in a 30 mile per hour perpendicular impact into a fixed collision barrier, the upper end of the steering column and shaft in the vehicle shall not be displaced more than 5 inches in a horizontal rearward direction parallel to the longitudinal axis of the vehicle. The amount of displacement shall be measured relative to an undisturbed point on the vehicle and shall represent the maximum dynamic movement of the upper end of the steering column and shaft during the crash test.S4.2Vehicles manufactured on or after September 1, 1991. When a passenger car or a truck, bus or multipurpose passenger vehicle with a gross vehicle weight rating of 4,536 kg or less and an unloaded vehicle weight of 2,495 kg or less is tested under the conditions of S5 in a 48 km/h perpendicular impact into a fixed collision barrier, the upper end of the steering column and shaft in the vehicle shall not be displaced more than 127 mm in a horizontal rearward direction parallel to the longitudinal axis of the vehicle. The amount of displacement shall be measured relative to an undisturbed point on the vehicle and shall represent the maximum dynamic movement of the upper end of the steering column and shaft during the crash test.S5.Test conditions. The requirements of S4 shall be met when the vehicle is tested in accordance with the following conditions.S5.1 The vehicle, including test devices and instrumentation, is loaded to its unloaded vehicle weight.S5.2 Adjustable steering controls are adjusted so that a tilting steering wheel hub is at the geometric center of the locus it describes when it is moved through its full range of driving positions. A telescoping steering control is set at the adjustment position midway between the forwardmost and rearwardmost position.S5.3 Convertibles and open-body type vehicles have the top, if any, in place in the closed passenger compartment configuration.S5.4 Doors are fully closed and latched but not locked.S5.5 The fuel tank is filled to any level from 90 to 95 percent of capacity.S5.6 The parking brake is disengaged and the transmission is in neutral.S5.7 Tires are inflated to the vehicle manufacturer's specifications.52 FR 44897, Nov. 23, 1987, as amended at 63 FR 28935, May 27, 1998; 63 FR 51003, Sept. 24, 1998; 87 FR 18588 , Mar. 30, 2022