47 C.F.R. § 87.147

Current through October 31, 2024
Section 87.147 - Authorization of equipment
(a) Certification may be requested by following the procedures in part 2 of this chapter. Aircraft transmitters must meet the requirements over an ambient temperature range of -20 degrees to + 50 degrees Celsius.
(b) ELTs manufactured after October 1, 1988, must meet the output power characteristics contained in § 87.141(i) . A report of the measurements must be submitted with each application for certification. ELTs that meet the output power characteristics of the section must have a permanent label prominently displayed on the outer casing state, "Meets FCC Rule for improved satellite detection." This label, however, must not be placed on the equipment without authorization to do so by the Commission. Application for such authorization may be made either by submission of a new application for certification accompanied by the required fee and all information and test data required by parts 2 and 87 of this chapter or, for ELTs approved prior to October 1, 1988, a letter requesting such authorization, including appropriate test data and a showing that all units produced under the original equipment authorization comply with the requirements of this paragraph without change to the original circuitry.
(c) An applicant for a station license may request certification for an individual transmitter by following the procedure in part 2 of this chapter. Such a transmitter will be individually certified and so noted on the station license.
(d) An applicant for certification of equipment intended for transmission in any of the frequency bands listed in paragraph (d)(3) of this section must notify the FAA of the filing of a certification application. The letter of notification must be mailed to: FAA, Office of Spectrum Policy and Management, ASR-1, 800 Independence Ave., SW., Washington, DC 20591 prior to the filing of the application with the Commission.
(1) The notification must describe the equipment, give the manufacturer's identification, antenna characteristics, rated output power, emission type and characteristics, the frequency or frequencies of operation, and essential receiver characteristics if protection is required.
(2) The certification application must include a copy of the notification letter to the FAA. The Commission will not act until it receives the FAA's determination regarding whether it objects to the application for equipment authorization. The FAA should mail its determination to: Office of Engineering and Technology Laboratory, Authorization and Evaluation Division, 7435 Oakland Mills Rd., Columbia, MD 21046. The Commission will consider the FAA determination before taking final action on the application.
(3) The frequency bands are as follows:

90-110 kHz

190-285 kHz

325-435 kHz

74.800 MHz to 75.200 MHz

108.000 MHz to 137.000 MHz

328.600 MHz to 335.400 MHz

960.000 MHz to 1215.000 MHz

1545.000 MHz to 1626.500 MHz

1646.500 MHz to 1660.500 MHz

5000.000 MHz to 5250.000 MHz

14.000 GHz to 14.400 GHz

15.400 GHz to 15.700 GHz

24.250 GHz to 25.250 GHz

31.800 GHz to 33.400 GHz

(e) Supplier's Declaration of Conformity for ELTs capable of operating on the frequency 406.0-406.1 MHz must include sufficient documentation to show that the ELT meets the requirements of § 87.199(a) . A letter notifying the FAA of the ELT Supplier's Declaration of Conformity must be mailed to: FAA, Office of Spectrum Policy and Management, ASR-1, 800 Independence Avenue SW., Washington, DC 20591.

Note 1 to paragraph (e): The verification procedure has been replaced by Supplier's Declaration of Conformity. Equipment previously authorized under subpart J of part 2 of this chapter may remain in use. See § 2.950 of this chapter.

(f) Certification may be requested for equipment that has the capability to transmit in the 138-144 MHz, 148-149.9 MHz, or 150.5-150.8 MHz bands as well as frequency bands set forth in § 87.173 . The Commission will only certify this equipment for use in the bands regulated by this part.

47 C.F.R. §87.147

53 FR 28940, Aug. 1, 1988, as amended at 54 FR 11721, Mar. 22, 1989; 56 FR 11518, Mar. 19, 1991; 57 FR 45750, Oct. 5, 1992; 58 FR 30127, May 26, 1993; 58 FR 67696, Dec. 22, 1993; 63 FR 36608, July 7, 1998; 69 FR 32881 , June 14, 2004; 82 FR 50837 , Nov. 2, 2017; 83 FR 63812 , Dec. 12, 2018
82 FR 50837 , 11/2/2017; 83 FR 63812 , 1/11/2019