Section 162.060-34 - Test Report requirementsThe Test Report prepared and submitted by an independent laboratory must be formatted as set out below. The Test Report must include, in addition to the information required by 46 CFR 159.005-11 , information as follows:
(a) Summary statement with the following information:(1) Name of the independent laboratory (IL) and all test facilities, subcontractors, and test organizations involved in testing the ballast water management system (BWMS).(2) Name of manufacturer.(4) The IL's assessment that the BWMS- (i) Has demonstrated, under the procedures and conditions specified in this subpart for both land-based and shipboard testing, that it meets the ballast water discharge standard requirements of 33 CFR part 151, subparts C and D;(ii) Is designed and constructed according to the requirements of § 162.060-20 of this subpart;(iii) Is in compliance with all applicable U.S. Environmental Protection Agency (EPA) requirements;(iv) Operates at the rated capacity, performance, and reliability as specified by the manufacturer;(v) Contains control and monitoring equipment that operates correctly;(vi) Was installed in accordance with the technical installation specification of the manufacturer for all tests; and(vii) Was used to treat volumes and flow rates of ballast water during the shipboard tests consistent with the normal ballast operations of the vessel.(c) Introduction and background.(d) Description of the BWMS.(e) For each test conducted, summary descriptions of-(3) Methods and procedures; and(4) Results and discussion.(f) Appendices, including-(1) Complete Test Plans for land-based, shipboard, and component tests, for which an EPA Environmental Technology Verification (ETV) Verification Report produced in accordance with the ETV Protocol can substitute for the land-based test plan;(2) Manufacturer supplied Operation, Maintenance, and Safety Manual that meets the requirements of § 162.060-38 of this subpart;(3) Data generated during testing and evaluations;(4) Quality Assurance and Quality Control records;(6) Relevant records and tests results maintained or created during testing;(7) Information on hazardous materials, active substances, relevant chemicals, and pesticides as detailed in paragraph (g) of this section; and(8) Permits, registrations, restrictions, and regulatory limitations on use.(g) The Test Report for a BWMS that may incorporate, use, produce, generate as a by-product and/or discharge hazardous materials, active substances, relevant chemicals and/or pesticides during its operation must include the following information in the appendix of the Test Report:(1) A list of each active substance or preparation used in the BWMS. For each active substance or preparation that is a pesticide and is not generated solely by the use of a device onboard the same vessel as the ballast water to be treated, the appendix must also include documentation that the sale or distribution of the pesticide is authorized under the Federal Insecticide, Fungicide, and Rodenticide Act for use for ballast water treatment. For all other active substances or preparations, the appendix must include documentation of the assessment specified in § 162.060-32(b) of this subpart.(2) A list of all hazardous materials, including the applicable hazard classes, proper shipping names, reportable quantities as designated by 40 CFR 117.1 , and chemical names of all components.