Section 111.30-29 - Emergency switchboards(a) Each emergency generator must have an emergency switchboard.(b) There must be a test switch at the emergency switchboard to simulate a failure of the normal power source and cause the emergency loads to be supplied from the emergency power source.(c) The emergency switchboard must be as near as practicable to the emergency power source but not in the same space as a battery emergency power source.(d) Each switchboard of an alternating-current emergency generator must have: (1) A circuit breaker that meets § 111.12-11 ;(2) A disconnect switch or link for each emergency generator conductor, except for a switchboard with a draw out or plug-in type generator circuit breaker that disconnects: (i) Each generator conductor; and(ii) If there is a switch in the generator neutral, each ungrounded conductor; and(3) An indicator light connected between the generator and circuit breaker.(e) For each emergency generator that is not excited from a variable voltage or rotary amplifier exciter that is controlled by a voltage regulator unit acting on the exciter field, each emergency switchboard must have:(1) A generator field rheostat;(2) A double pole field switch;(4) A discharge resistor.(f) Each emergency switchboard must have the following: (1) An ammeter with a selector switch that connects the ammeter to show the current for each phase.(2) A voltmeter with a selector switch that connects the voltmeter to show:(i) Generator voltage of each phase; and(ii) Bus voltage of one phase.(3) Ground detection that meets subpart 111.05 for the emergency lighting system.(5) An exciter field rheostat.(6) A voltage regulator and a voltage regulator functional cut-out switch.(g) Each direct-current emergency switchboard must have the:(1) Equipment under § 111.30-27 (b) through (d) ; and(2) Ground detection under subpart 111.05 for the emergency lighting system.CGD 74-125A, 47 FR 15236, Apr. 8, 1982, as amended by CGD 94-108, 61 FR 28279, June 4, 1996