Current through November 30, 2024
Section 1068.245 - Temporary provisions addressing hardship due to unusual circumstances(a) After considering the circumstances, we may permit you to introduce into U.S. commerce engines/equipment that do not comply with emission-related requirements for a limited time if all the following conditions apply:(1) Unusual circumstances that are clearly outside your control prevent you from meeting requirements from this chapter.(2) You exercised prudent planning and were not able to avoid the violation; you have taken all reasonable steps to minimize the extent of the nonconformity.(3) No other allowances are available under the regulations in this chapter to avoid the impending violation, including the provisions of § 1068.250 .(4) Not having the exemption will jeopardize the solvency of your company.(b) If your unusual circumstances are only related to compliance with the model-year provisions of § 1068.103(f) , we may grant hardship under this section without a demonstration that the solvency of your company is in jeopardy as follows:(1) You must demonstrate that the conditions specified in paragraphs (a)(1) through (3) of this section apply.(2) Your engines/equipment must comply with standards and other requirements that would have applied if assembly were completed on schedule.(3) You may generally request this exemption only for engines/equipment for which assembly has been substantially completed; you may not begin assembly of any additional engines/equipment under this exemption after the cause for delay has occurred. We may make an exception to this general restriction for secondary engine manufacturers.(4) As an example, if your normal production process involves purchase of partially complete engines and a supplier fails to deliver all the ordered engines in time for your assembly according to your previously established schedule as a result of a fire at its factory, you may request that we treat those engine as if they had been completed on the original schedule. Note that we would grant relief only for those engines where you had a reasonable basis for expecting the engines to be delivered on time based on past performance and terms of purchase.(c) To apply for an exemption, you must send the Designated Compliance Officer a written request as soon as possible before you are in violation. In your request, show that you meet all the conditions and requirements in paragraph (a) of this section.(d) Include in your request a plan showing how you will meet all the applicable requirements as quickly as possible.(e) You must give us other relevant information if we ask for it.(f) We may include reasonable additional conditions on an approval granted under this section, including provisions to recover or otherwise address the lost environmental benefit or paying fees to offset any economic gain resulting from the exemption. For example, in the case of multiple tiers of emission standards, we may require that you meet the standards from the previous tier whether or not your hardship is granted under paragraph (b) of this section.(g) Add a permanent label to all engines/equipment exempted under this section, consistent with § 1068.45 , with at least the following items: (1) The label heading "EMISSION CONTROL INFORMATION".(2) Your corporate name and trademark.(3) Engine displacement (in liters or cubic centimeters), and model year of the engine/equipment, (as applicable); or whom to contact for further information. We may also require that you include maximum engine power.(4) A statement describing the engine's status as an exempted engine: (i) If the engine/equipment does not meet any emission standards, add the following statement: "THIS [engine, equipment, vehicle, etc.] IS EXEMPT UNDER 40 CFR 1068.245 FROM EMISSION STANDARDS AND RELATED REQUIREMENTS."(ii) If the engines/equipment meet alternate emission standards as a condition of an exemption under this section, we may specify a different statement to identify the alternate emission standards. 73 FR 59344 , Oct. 8, 2008, as amended at 81 FR 74228 , Oct. 25, 2016