Section 1037.615 - Advanced technologies(a) This section describes how to calculate emission credits for advanced technologies. You may calculate Phase 1 advanced technology credits through model year 2020 for hybrid vehicles with regenerative braking, vehicles equipped with Rankine-cycle engines, battery electric vehicles, and fuel cell electric vehicles. You may calculate Phase 2 advanced technology credits through model year 2026 for plug-in hybrid electric vehicles, battery electric vehicles, and fuel cell electric vehicles. You may calculate Phase 3 advanced technology credits for model year 2027 for plug-in hybrid electric vehicles, battery electric vehicles, and fuel cell electric vehicles. You may not generate credits for Phase 1 engine technologies for which the engines generate CO2 credits under 40 CFR part 1036.(b) Generate Phase 1 advanced-technology credits for vehicles other than battery electric vehicles as follows: (1) Measure the effectiveness of the advanced system by chassis-testing a vehicle equipped with the advanced system and an equivalent conventional vehicle, or by testing the hybrid systems and the equivalent non-hybrid systems as described in § 1037.555 . Test the vehicles as specified in subpart F of this part. For purposes of this paragraph (b), a conventional vehicle is considered to be equivalent if it has the same footprint (as defined in 40 CFR 86.1803 ), vehicle service class, aerodynamic drag, and other relevant factors not directly related to the hybrid powertrain. If you use § 1037.540 to quantify the benefits of a hybrid system for PTO operation, the conventional vehicle must have the same number of PTO circuits and have equivalent PTO power. If you do not produce an equivalent vehicle, you may create and test a prototype equivalent vehicle. The conventional vehicle is considered Vehicle A and the advanced vehicle is considered Vehicle B. We may specify an alternate cycle if your vehicle includes a power take-off.(2) Calculate an improvement factor and g/ton-mile benefit using the following equations and parameters: (i) Improvement Factor = [(Emission Rate A)-(Emission Rate B)]/(Emission Rate A).(ii) g/ton-mile benefit = Improvement Factor * (GEM Result B).(iii) Emission Rates A and B are the g/ton-mile CO2 emission rates of the conventional and advanced vehicles, respectively, as measured under the test procedures specified in this section. GEM Result B is the g/ton-mile CO2 emission rate resulting from emission modeling of the advanced vehicle as specified in § 1037.520 .(3) If you apply an improvement factor to multiple vehicle configurations using the same advanced technology, use the vehicle configuration with the smallest potential reduction in greenhouse gas emissions resulting from the hybrid capability.(4) Use the equation in § 1037.705 to convert the g/ton-mile benefit to emission credits (in Mg). Use the g/ton-mile benefit in place of the (Std-FEL) term.(c) See § 1037.540 for special testing provisions related to Phase 1 vehicles equipped with hybrid power take-off units.(d) For Phase 2 and Phase 3 plug-in hybrid electric vehicles and for fuel cells powered by any fuel other than hydrogen, calculate CO2 credits using an FEL based on emission measurements from powertrain testing. Phase 2 and Phase 3 advanced technology credits do not apply for hybrid vehicles that have no plug-in capability.(f) For battery electric vehicles and for fuel cell electric vehicles, calculate CO2 credits using an FEL of 0 g/ton-mile. Note that these vehicles are subject to compression-ignition standards for CO2.(g) As specified in subpart H of this part, advanced-technology credits generated from Phase 1 vehicles under this section may be used under this part outside of the averaging set in which they were generated, or they may be used under 40 CFR part 86, subpart S, or 40 CFR part 1036. Advanced-technology credits generated from Phase 2 and later vehicles are subject to the averaging-set restrictions that apply to other emission credits.(h) You may certify using both provisions of this section and the off-cycle technology provisions of § 1037.610 , provided you do not double count emission benefits. 81 FR 74048 , Oct. 25, 2016, as amended at 86 FR 34490 , June 29, 2021; 88 FR 4652 , Jan. 24, 2023; 89 FR 29787 , Apr. 22, 2024 81 FR 74048, 10/25/2016, as amended at 86 FR 34490, 6/29/2021; 88 FR 4652, 3/27/2023; 89 FR 29787, 6/21/2024