40 C.F.R. § 60 app Table 3 to Subpart LLLL of Part 60

Current through September 30, 2024

Appendix Table 3 to Subpart LLLL of Part 60 - Operating Parameters for New Sewage Sludge Incineration Units [a]

For these operating parameters	You must establish these operating limits	And monitor using these minimum frequencies
		Data measurement	Data recordingb	Data averaging period for compliance
All sewage sludge incineration units
Combustion chamber operating temperature or afterburner temperature	Minimum combustion chamber operating temperature or afterburner temperature	Continuous	Every 15 minutes	12-hour block.
Fugitive emissions from ash handling	Site-specific operating requirements	Not applicable	Not applicable	Not applicable.
Scrubber
Pressure drop across each wet scrubber	Minimum pressure drop	Continuous	Every 15 minutes	12-hour block.
Scrubber liquid flow rate	Minimum flow rate	Continuous	Every 15 minutes	12-hour block.
Scrubber liquid pH	Minimum pH	Continuous	Every 15 minutes	3-hour block.
Fabric Filter
Alarm time of the bag leak detection system alarm	Maximum alarm time of the bag leak detection system alarm (this operating limit is provided in § 60.4850 and is not established on a site-specific basis).
Electrostatic precipitator
Secondary voltage of the electrostatic precipitator collection plates	Minimum power input to the electrostatic precipitator collection plates	Continuous	Hourly	12-hour block.
Secondary amperage of the electrostatic precipitator collection plates
Effluent water flow rate at the outlet of the electrostatic precipitator	Minimum effluent water flow rate at the outlet of the electrostatic precipitator	Hourly	Hourly	12-hour block.
Activated carbon injection
Mercury sorbent injection rate	Minimum mercury sorbent injection rate	Hourly	Hourly	12-hour block.
Dioxin/furan sorbent injection rate	Minimum dioxin/furan sorbent injection rate
Carrier gas flow rate or carrier gas pressure drop	Minimum carrier gas flow rate or minimum carrier gas pressure drop	Continuous	Every 15 minutes	12-hour block.

^a As specified in § 60.4870 , you may use a continuous emissions monitoring system or continuous automated sampling system in lieu of establishing certain operating limits.

^b This recording time refers to the minimum frequency that the continuous monitor or other measuring device initially records data. For all data recorded every 15 minutes, you must calculate hourly arithmetic averages. For all parameters, you use hourly averages to calculate the 12-hour or 3-hour block average specified in this table for demonstrating compliance. You maintain records of 1-hour averages.

40 C.F.R. 60 app Table 3 to Subpart LLLL of Part 60