Section 71.101 - [Effective until 4/14/2025] Respirable dust standard when quartz is present(a) Each operator shall continuously maintain the average concentration of respirable quartz dust in the mine atmosphere during each shift to which each miner in the active workings of each mine is exposed at or below 0.1 mg/m3 (100 micrograms per cubic meter or [MICRO]g/m3) as measured with an approved sampling device and expressed in terms of an equivalent concentration.(b) When the equivalent concentration of respirable quartz dust exceeds 100 [MICRO]g/m3, the operator shall continuously maintain the average concentration of respirable dust in the mine atmosphere during each shift to which each miner in the active workings is exposed as measured with an approved sampling device and expressed in terms of an equivalent concentration at or below the applicable standard. The applicable standard is computed by dividing the percent of quartz into the number 10. The application of this formula shall not result in the applicable standard that exceeds the standard established by § 71.100(a) of this section. Example: Assume the sampled DWP is on a 1.5-mg/m3 dust standard. Suppose a valid representative dust sample with an equivalent concentration of 1.09 mg/m3 contains 16.7% of quartz dust, which corresponds to a quartz concentration of 182 [MICRO]g/m3. Therefore, the average concentration of respirable dust in the mine atmosphere associated with that DWP shall be maintained on each shift at or below 0.6 mg/m3 (10/16.7% = 0.6 mg/m3).