24 C.F.R. § 3282.406

Current through October 31, 2024
Section 3282.406 - Required manufacturer correction
(a)Correction of noncompliances and defects.
(1) Section 3282.415 sets out requirements with respect to a manufacturer's correction of any noncompliance or defect that exists in each manufactured home that has been sold or otherwise released to a retailer but that has not yet been sold to a purchaser.
(2) In accordance with section 623 of the Act and Part 3288, "Manufactured Home Dispute Resolution Program," of this chapter, the manufacturer, retailer, or installer of a manufactured home deemed responsible for correction of repairs or defects must correct, at its expense, each failure in the performance, construction, components, or material of the home that renders the home or any part of the home not fit for the ordinary use for which it was intended and that is reported during the one-year period beginning on the date of installation of the home (see § 3286.115 ).
(b)Correction of serious defects and imminent safety hazards.
(1) A manufacturer required to furnish notification under § 3282.405 or § 3282.413 must correct, at its expense, any serious defect or imminent safety hazard that can be related to an error in design or assembly of the manufactured home by the manufacturer, including an error in design or assembly of any component or system incorporated into the manufactured home by the manufacturer.
(2) If, while making corrections under any of the provisions of this subpart, the manufacturer creates an imminent safety hazard or serious defect, the manufacturer shall correct the imminent safety hazard or serious defect.
(3) Each serious defect or imminent safety hazard corrected under this paragraph (b) must be brought into compliance with applicable construction and safety standards or, where those standards are not specific, with the manufacturer's approved design.
(c)Inclusion in plan.
(1) In the plan required by § 3282.408 , the manufacturer must provide for correction of those homes that are required to be corrected pursuant to paragraph (b) of this section.
(2) If the Secretary or SAA orders a manufacturer to provide correction in accordance with the procedures in § 3282.413 , the Secretary or SAA has the option of requiring a manufacturer to prepare and receive approval on a plan for correction.
(d)Corrections by owners. A manufacturer that is required to make corrections under paragraph (b) of this section, or that elects to make corrections in accordance with § 3282.407 , must reimburse any owner of an affected manufactured home who choses to make the correction before the manufacturer did so, for the reasonable cost of correction.
(e)Correction of appliances, components, or systems.
(1) If any appliance, component, or system in a manufactured home is covered by a product warranty, the manufacturer, retailer, or installer that is responsible under this section for correcting a noncompliance, defect, serious defect, or imminent safety hazard in the appliance, component, or system may seek the required correction directly from the producer. The SAA that approves any plan of notification required pursuant to § 3282.408 or the Secretary, as applicable, may establish reasonable time limits for the manufacturer of the home and the producer of the appliance, component, or system to agree on who is to make the correction and for completing the correction.
(2) Nothing in this section shall prevent the manufacturer, retailer, or installer from seeking indemnification from the producer of the appliance, component, or system for correction work done on any appliance, component, or system.

24 C.F.R. §3282.406