16 C.F.R. § 1500.41
Guidelines for testing the dermal irritation and corrosivity properties of substances, including testing that does not require animals, are presented in the CPSC's animal testing policy set forth in 16 CFR 1500.232 . A weight-of-evidence analysis or a validated in vitro test method is recommended to evaluate existing information before in vivo tests are considered. This analysis should include all of the following that are available: human and animal data, structure activity relationships, physicochemical properties, and dermal toxicity. If in vivo testing is conducted, a sequential testing strategy is recommended to reduce the number of test animals. The method of testing the dermal corrosivity and primary irritation of substances referred to in § 1500.3(c)(3) and (4) , respectively, is a patch-test technique on the abraded and intact skin of the albino rabbit, clipped free of hair. Primary irritation to the skin is measured by a patch-test technique on the abraded and intact skin of the albino rabbit, clipped free of hair. A minimum of six subjects are used in abraded and intact skin tests. Introduce under a square patch, such as surgical gauze measuring 1 inch by 1 inch and two single layers thick, 0.5 milliliter (in the case of liquids) or 0.5 gram (in the case of solids and semisolids) of the test substance. Dissolve solids in an appropriate solvent and apply the solution as for liquids. The animals are immobilized with patches secured in place by adhesive tape. The entire trunk of the animal is then wrapped with an impervious material, such as rubberized cloth, for the 24-hour period of exposure. This material aids in maintaining the test patches in position and retards the evaporation of volatile substances. After 24 hours of exposure, the patches are removed and the resulting reactions are evaluated on the basis of the designated values in the following table:
| Skin reaction | Value1 |
| Erythema and eschar formation: | |
| No erythema | 0 |
| Very slight erythema (barely perceptible) | 1 |
| Well-defined erythema | 2 |
| Moderate to severe erythema | 3 |
| Severe erythema (beet redness) to slight eschar formations (injuries in depth) | 4 |
| Edema formation: | |
| No edema | 0 |
| Very slight edema (barely perceptible) | 1 |
| Slight edema (edges of area well defined by definite raising) | 2 |
| Moderate edema (raised approximately 1 millimeter) | 3 |
| Severe edema (raised more than 1 millimeter and extending beyond the area of exposure) | 4 |
1 The "value" recorded for each reading is the average value of the six or more animals subject to the test.
Readings are again made at the end of a total of 72 hours (48 hours after the first reading). An equal number of exposures are made on areas of skin that have been previously abraded. The abrasions are minor incisions through the stratum corneum, but not sufficiently deep to disturb the derma or to produce bleeding. Evaluate the reactions of the abraded skin at 24 hours and 72 hours, as described in this paragraph. Add the values for erythema and eschar formation at 24 hours and at 72 hours for intact skin to the values on abraded skin at 24 hours and at 72 hours (four values). Similarly, add the values for edema formation at 24 hours and at 72 hours for intact and abraded skin (four values). The total of the eight values is divided by four to give the primary irritation score; for example:
| Skin reaction | Exposure time (hours) | Evaluation value |
| Erythema and eschar formation: | ||
| Intact skin | 24 | 2 |
| Do | 72 | 1 |
| Abraded skin | 24 | 3 |
| Do | 72 | 2 |
| Subtotal | 8 | |
| Edema formation: | ||
| Intact skin | 24 | 0 |
| Do | 72 | 1 |
| Abraded skin | 24 | 1 |
| Do | 72 | 2 |
| Subtotal | 4 | |
| Total | 12 |
Thus, the primary irritation score is 12 ÷ 4 = 3.
16 C.F.R. §1500.41