Section 417.218 - [Effective until 3/10/2026] Hold-and-resume gate analysis(a) For a launch that involves overflight or near overflight of a populated or otherwise protected area prior to the planned safe flight state calculated as required by § 417.219 , the flight safety analysis must construct a hold-and-resume gate for each populated or otherwise protected area. After a vehicle's tracking icon crosses a hold-and-resume gate, flight termination must occur as required by sections 417.113(d)(6) .(b) The hold-and-resume gate analysis must account for: (1)Overflight of a wholly contained populated or otherwise protected area. A hold-and-resume gate must be a closed, continuous contour that encompasses any populated or otherwise protected area located wholly within the impact limit lines. The hold-and-resume gate must encompass a populated or otherwise protected area such that flight termination or breakup of the launch vehicle while the tracking icon is outside the gate would not cause hazardous debris or overpressure to endanger the populated or otherwise protected area.(2)Overflight of an uncontained populated or otherwise protected area. A hold-and-resume gate must be a closed, continuous contour that encompasses any area in which flight termination is allowed to occur. The hold-and-resume gate must encompass all hazard areas such that flight termination or breakup of the launch vehicle while the vehicle's tracking icon is inside the gate would not cause hazardous debris or critical overpressure to endanger any populated or otherwise protected area.