Section 431.343 - Materials incorporated by reference(a)General. DOE incorporates by reference the following standards into part 431. The material listed has been approved for incorporation by reference by the Director of the Federal Register in accordance with 6 U.S.C. 522(a) and 1 CFR part 51 . Any subsequent amendment to a standard by the standard-setting organization will not affect the DOE test procedures unless and until amended by DOE. Material is incorporated as it exists on the date of the approval and a notice of any change in the material will be published in the FEDERAL REGISTER. All approved material is available from the sources below. It is available for inspection at U.S. Department of Energy, Office of Energy Efficiency and Renewable Energy, Building Technologies Program, Sixth Floor, 950 L'Enfant Plaza SW., Washington, DC 20024, (202) 586-6636, or go to http://www1.eere.energy.gov/buildings/appliance_standards/. Also, this material is available for inspection at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html.(b)ISO. International Organization for Standardization, Chemin de Blandonnet 8, CP 401, 1214 Vernier, Geneva, Switzerland +41 22 749 01 11, www.iso.org.(1) ISO Standard 1217:2009(E), ("ISO 1217:2009(E)"), "Displacement compressors-Acceptance tests," July 1, 2009, IBR approved for appendix A to this subpart:(i) Section 2. Normative references;(ii) Section 3. Terms and definitions;(iii) Section 4. Symbols;(iv) Section 5. Measuring equipment, methods and accuracy (excluding 5.1, 5.5, 5.7, and 5.8);(v) Section 6. Test procedures, introductory text to Section 6.2 , Test arrangements, and paragraphs 6.2(g) and 6.2(h) including Table 1-Maximum deviations from specified values and fluctuations from average readings;(vi) Annex C (normative), Simplified acceptance test for electrically driven packaged displacement compressors (excluding C.1.2, C.2.1, C.3, C.4.2.2, C.4.3.1, and C.4.5).(2) ISO 1217:2009/Amd.1:2016(E), Displacement compressors-Acceptance tests (Fourth edition); Amendment 1: "Calculation of isentropic efficiency and relationship with specific energy," April 15, 2016, IBR approved for appendix A to this subpart: (i) Section 3.5.1 : isentropic power;(ii) Section 3.6.1 : isentropic efficiency;(iii) Annex H (informative), Isentropic efficiency and its relation to specific energy requirement, sections H.2, Symbols and subscripts, and H.3, Derivation of isentropic power.