Cal. Code Regs. tit. 8 § 4600

Current through Register 2024 Notice Reg. No. 50, December 13, 2024
Section 4600 - Injection Molding Machine

Every injection molding machine shall be guarded:

(a) By a sliding gate guard so designed and installed that it interposes a barrier between the dies and the operator before the dies can close and shall be so arranged that if the gate can be opened during the die closing cycle the die motion will be immediately stopped by the opening of the gate.

The sliding gate guard shall extend over the top and to each side of the dies to prevent the operator from placing his/her hands between the dies while they are closing. The danger zone on the side of the machine opposite the operator's working position shall also be guarded, or

(b) By two-handed constant pressure devices or controls which require the simultaneous use of both the operator's hands during the entire die closing cycle.

Cal. Code Regs. Tit. 8, § 4600

1. Amendment filed 4-25-86; effective thirtieth day thereafter (Register 86, No. 17).

Note: Authority cited: Section 142.3, Labor Code. Reference: Section 142.3, Labor Code.

1. Amendment filed 4-25-86; effective thirtieth day thereafter (Register 86, No. 17).