Section 5601 - Tank Openings Other than Vents for Tanks Inside Buildings(a) Connections for all tank openings shall be liquid-tight.(b) Each connection to a tank inside of buildings through which liquid can normally flow shall be provided with an internal or an external valve located as close as practical to the shell of the tank.(c) Flammable or combustible liquid storage tanks located inside of buildings, except in one-story buildings designed and protected for flammable or combustible liquid storage, shall be provided with an automatic-closing heat-actuated valve on each withdrawal connection below the liquid level, except for connections used for emergency disposal, to prevent continued flow in the event of fire in the vicinity of the tank. This function may be incorporated in the valve required in (b), and if a separate valve, shall be located adjacent to the valve required in (b).(d) Openings for manual gaging of Category 1, 2 or 3 flammable liquids, if independent of the fill pipe, shall be provided with a vaportight cap or cover. Openings shall be kept closed when not gaging. Each such opening for any liquid shall be protected against liquid overflow and possible vapor release by means of a spring loaded check valve or other approved device. Substitutes for manual gaging include, but are not limited to, heavy-duty flat gage glasses, magnetic, hydraulic or hydrostatic remote reading devices and sealed float gages.(e) For Category 2 flammable liquids and Category 3 flammable liquids with a flashpoint below 100 °F (37.8 °C), other than crude oils, gasolines and asphalts, the fill pipe shall be so designed and installed as to minimize the possibility of generating static electricity by terminating within six inches of the bottom of the tank.(f) The fill pipe inside of the tank shall be installed to avoid excessive vibration of the pipe.(g) The inlet of the fill pipe for Category 1, 2, 3, and 4 flammable liquids shall be located outside of buildings at a location free from any source of ignition and not less than five feet away from any building opening. The inlet of the fill pipe for any liquid shall be closed and liquid-tight when not in use, and the fill connection shall be properly identified.(h) Tanks storing Category 1, 2, 3, and 4 flammable liquids inside buildings shall be equipped with a device, or other means shall be provided, to prevent overflow into the building. Suitable devices include, but are not limited to, a float valve, a preset meter on the fill line, a valve actuated by the weight of the tank contents, a low head pump which is incapable of producing overflow, or a liquid-tight overflow pipe at least one pipe size larger than the fill pipe discharging by gravity back to the outside source of liquid or to an approved location.Cal. Code Regs. Tit. 8, § 5601
1. Amendment of subsections (d)-(e) and (g)-(h) and new NOTE filed 5-5-2014; operative 5-6-2014 pursuant to Government Code section 11343.4(b)(3) (Register 2014, No. 19). Note: Authority cited: Section 142.3, Labor Code. Reference: Section 142.3, Labor Code.
1. Amendment of subsections (d)-(e) and (g)-(h) and new Note filed 5-5-2014; operative 5/6/2014 pursuant to Government Code section 11343.4(b)(3) (Register 2014, No. 19).