Article 98 - Operating Rules
- Section 4990 - Scope
- Section 4991 - Travel
- Section 4991.1 - Ground Conditions
- Section 4992 - Booms
- Section 4993 - Swing
- Section 4993.1 - Work Area Control
- Section 4994 - Hoisting
- Section 4995 - Riding Loads on Derricks, Hoists, or Cranes
- Section 4996 - Driver's Position
- Section 4997 - Fire Extinguisher
- Section 4998 - Refueling
- Section 4999 - Handling Loads
- Section 5000 - Limit Switches
- Section 5001 - Signals - General Requirements
- Recommended Hand Signals for Controlling Crane Operations
- Section 5001.1 - Signals - Radio, Telephone or Other Electronic Transmission of Signals
- Section 5001.2 - Signals - Voice Signals - Additional Requirements
- Section 5001.3 - Signal Person Qualifications - Supplemental Requirements for Cranes and Derricks in Construction
- Section 5002 - Overhead Loads
- Section 5003 - Provisions for Preventing Accidents in the Area of High-Voltage Lines
- Section 5003.1 - Power Line Safety (up to and Including 350kv) - Equipment Operations
- Section 5003.2 - Power Line Safety (over 350kv)
- Section 5003.3 - Power Line Safety (All Voltages) - Equipment Operations Closer than the Table a Zone
- Section 5003.4 - Power Line Safety - While Traveling Under or near Power Lines with NO Load
- Section 5004 - Crane or Derrick Suspended Personnel Platforms
- Section 5005 - Work near Transmitter Towers
- Section 5006 - Crane and Hoisting Equipment Operators-Qualifications
- Section 5006.1 - Mobile Crane and Tower Crane - Operator Qualifications and Certification (Applicable to Cranes in General Industry Only)
- Section 5006.2 - Operator Training, Certification, and Evaluation for Cranes and Derricks in Construction
- Section 5008 - Operating Practices
- Section 5008.1 - Operation
- Section 5009 - Floor-Operated Cranes
- Section 5010 - Assembly/Disassembly - Selection of Manufacturer or Employer Procedures
- Section 5010.1 - Assembly/Disassembly - General Requirements (Applies to All Assembly and Disassembly Operations)
- Section 5010.2 - Disassembly - Additional Requirements for Dismantling of Booms and Jibs (Applies to Both the Use of Manufacturer Procedures and Employer Procedures)
- Section 5010.3 - Assembly/Disassembly - Employer Procedures - General Requirements
- Section 5010.4 - Power Line Safety (up to and Including 350kv) - Assembly and Disassembly
- Section 5011 - Fall Protection - Supplemental/Specific Requirements for Cranes
- Section 5012 - Training - Supplemental Requirements for Cranes in Construction