Cal. Code Regs. tit. 8 § 7096

Current through Register 2024 Notice Reg. No. 50, December 13, 2024
Section 7096 - (5-1). Dust, Smoke, and Gases from Secondary Blasting
(a) In order to protect employees from harmful dust, smoke, and gases from secondary blasting, such blasting shall not be done unnecessarily during the working shift.
(b) At permanent locations, such as bulldozing chambers, main grizzlies, draw points, and other control points where blasting is done throughout the working shift in the regular course of the work, employees shall be protected by one or more of the following, as necessary:
(1) A ventilation system that carries dust, smoke, and gases directly into the return air without circulation through any active working place.
(2) A system of water sprays that will blanket the area with a fine spray or mist during blasting, and long enough thereafter that the dust, smoke, and gases are allayed.
(3) Removal of employees from all areas of contamination until the atmosphere is reasonably free of dust, smoke, and gases.
(c) When blasting a chute that is equipped with water sprays, it is recommended that the sprays be turned on before the shot is fired.
(d) After a secondary blast has been fired, employees shall not be required or permitted to return to the blast area until the atmosphere is reasonably free of dust, smoke, and gases from the blast.
(e) If the amount of explosive used or the frequency of secondary blasting is such that serious contamination of active working places is apt to occur, employees in such places shall be removed to the fresh air side of the blast area.

Such employees shall not be required or permitted to return to their working places until the atmosphere is reasonably free of dust, smoke, or gases.

Cal. Code Regs. Tit. 8, § 7096