Section 1436 - Electrical Installations(a) Electrical equipment and installations within an accessory building or structure or building component and the circuit supplying power shall be installed by a permanent wiring method and shall comply with the requirements for electrical installations of this chapter.(b) Flexible cord shall not be used to supply an accessory building or structure or building component, or as a substitute for the fixed wiring of an accessory building or structure or building component.(c) Unless otherwise specified by this article, electrical service provided to an accessory building or structure or building component may be supplied by either of the following: (1) from the lot service equipment, provided: (A) a permit is obtained to alter the lot electrical service by installing a separate overcurrent protective device rated not more than the total calculated electrical load, and(B) the lot service equipment is capable of supplying the additional load, and(C) the overcurrent protective device and its installation complies with the California Electrical Code.(2) from an MH-unit provided: (A) the MH-unit is capable of supplying the additional load, and(B) a permit to alter the MH-unit's electrical system, substantiated with load calculations, is obtained from the department pursuant to the California Code of Regulations, Title 25, Division 1, Chapter 3.Cal. Code Regs. Tit. 25, § 1436
1. Amendment of section and NOTE filed 7-6-2004; operative 7-6-2004 pursuant to Government Code section 11343.4 (Register 2004, No. 28). Note: Authority cited: Section 18300, Health and Safety Code. Reference: Sections 18029, 18552 and 18670, Health and Safety Code.
1. Amendment of section andNotefiled 7-6-2004; operative 7-6-2004 pursuant to Government Code section 11343.4 (Register 2004, No. 28).