Ariz. Admin. Code § 18-5-232

Current through Register Vol. 30, No. 50, December 13, 2024

Section R18-5-232 - Overflow Collection Systems

A. An overflow collection system shall be installed in each public or semipublic swimming pool or spa.

B. The overflow collection system shall be designed and constructed so that the water level of the swimming pool is maintained at the mid-point of the operating range of the system's rim or weir device.

C. Rim type overflow collection systems shall be installed on at least two opposite sides and have a total length of at least 50% of the perimeter of a public or semipublic swimming pool. The overflow collection system shall be capable of carrying 50% of the design capacity of the water circulation system.

D. If overflow gutters are used, they shall be installed continuously around the swimming pool with the lip of the gutter level throughout its perimeter. Overflow gutters shall be provided with sufficient opening at the top and width at the bottom to permit easy cleaning. The overflow gutter bottom shall be pitched 1/4 inch per foot to drainage outlets located not more than 10 feet apart. Outlet piping shall be sized to circulate at least 50% of the capacity of the water circulation system and be properly covered by a drain grate. The surge tank for the overflow gutters shall be equipped with float controls which regulate the main drain, fill line, and overflow. The system surge capacity shall not be less than one gallon for each square foot of swimming pool surface area. Stainless steel gutters and other specialty gutter systems may be used if they are hydraulically equivalent to overflow gutters.

E. Surface skimmers shall be recessed into the swimming pool or spa wall and shall be installed to achieve effective skimming action throughout the swimming pool or spa.

1. A surface skimmer shall be provided for each 400 square feet of surface area, or fraction thereof, of a public or semipublic swimming pool. A minimum of two surface skimmers are required in a public or semipublic swimming pool. A surface skimmer shall be provided for each 200 square feet of surface area, or fraction thereof, of a public or semipublic spa.

2. The overflow slot shall be set level and shall not be less than 8 inches in width at the narrowest section.

3. The rate of flow through the skimmers shall be a minimum of 75% of the water circulation system capacity. Surface skimmers shall be designed to carry at least 30 gallons per minute per lineal foot of weir throat.

4. Where three or more surface skimmers are used, they must be on a closed loop piping system.

5. At least one surface skimmer shall be located on the side or near the corner of the swimming pool that is downwind of the area's prevailing winds.

6. Main drain piping shall be designed to carry at least 50% of the design flow.

F. Mixed inlet types [for example, surface skimmers and gutters] are prohibited in a public or semipublic swimming pool.

Ariz. Admin. Code § R18-5-232

Adopted effective February 19, 1998 (Supp. 98-1).