Ariz. Admin. Code § tit. 18, ch. 11, art. 6, tbl. 1

Current through Register Vol. 30, No. 45, November 8, 2024

Table 1 - Minimum Number of Samples Exceeding the Numeric Standard

MINIMUM NUMBER OF SAMPLES EXCEEDING THE NUMERIC STANDARD
Number of Samples		Number of Samples Exceeding Standard	Number of Samples		Number of Samples Exceeding Standard	Number of Samples		Number of Samples Exceeding Standard
From	To		From	To		From	To
10	15	3	173	181	22	349	357	41
16	23	4	182	190	23	358	367	42
24	31	5	191	199	24	368	376	43
32	39	6	200	208	25	377	385	44
40	47	7	209	218	26	386	395	45
48	56	8	219	227	27	396	404	46
57	65	9	228	236	28	405	414	47
66	73	10	237	245	29	415	423	48
74	82	11	246	255	30	424	432	49
83	91	12	256	264	31	433	442	50
92	100	13	265	273	32	443	451	51
101	109	14	274	282	33	452	461	52
110	118	15	283	292	34	462	470	53
119	126	16	293	301	35	471	480	54
127	136	17	302	310	36	481	489	55
137	145	18	311	320	37	490	499	56
146	154	19	321	329	38	500		57
155	163	20	330	338	39
164	172	21	339	348	40

2. When there are less than ten samples, the Department shall place a surface water or segment on the Planning List following subsection (B), if three or more temporally independent samples exceed the following surface water quality standards:

a. The surface water quality standard for a pollutant listed in 18 A.A.C. 11, Article 1, Appendix A, Table 1, except for nitrate or nitrate/nitrite;

b. The surface water quality standard for temperature or the single sample maximum water quality standard for suspended sediment concentration, nitrogen, and phosphorus in R18-11-109;

c. The surface water quality standard for radiochemicals in R18-11-109(G);

d. The surface water quality standard for dissolved oxygen under R18-11-109(E);

e. The surface water quality standard for pH under R18-11-109(B); or

f. The following surface water quality standards in R18-11-112:

i. Single sample maximum standards for nitrogen and phosphorus,

ii. All metals except chromium, or

iii. Turbidity.

3. The Department shall place a surface water or segment on the Planning List if information in subsections (B)(2)(c), (B)(2)(d), and (B)(2)(e) indicates that a narrative water quality standard violation exists, but no narrative implementation procedure required under A.R.S. § 49-232(F) exists to support use of the information for listing.

D. 303(d) List.

1. When evaluating a surface water or segment for placement on the 303(d) List.

a. Consider at least 20 spatially or temporally independent samples collected over three or more temporally independent sampling events; and

b. Determine numeric water quality standards exceedances. The Department shall:

i. Place a surface water or segment on the 303(d) List, following subsection (B), if the number of exceedances of a surface water quality standard is greater than or equal to the number listed in Table 2, which provides the number of exceedances that indicate a minimum of a 10 percent exceedance frequency with a minimum of a 90 percent confidence level using a binomial distribution, for a given sample size; or

ii. For sample datasets exceeding those shown in Table 2, calculate the number of exceedances using the following equation: (X[GREATOR THAN EQUAL TO]x| n, p) where n = number of samples; p = exceedance probability of 0.1; x = smallest number of exceedances required for listing with "n" samples; and confidence level [GREATOR THAN EQUAL TO] 90 percent.

Ariz. Admin. Code tit. 18, ch. 11, art. 6, tbl. 1