Goodyear Tire and Rubber Company, (Goodyear), has determined that approximately 26,224 Goodyear Assurance ComforTred Touring passenger replacement car tires manufactured between January 4, 2010 and September 11, 2010, do not fully comply with paragraph S5.5(e) of Federal Motor Vehicle Safety Standard (FMVSS) No. 139, New Pneumatic Radial Tires for Light Vehicles. Goodyear has filed an appropriate report pursuant to 49 CFR part 573, Defect and Noncompliance Responsibility and Reports, dated December 16, 2010.
Goodyear Tire and Rubber Company (Goodyear) is a replacement equipment manufacturer incorporated in the state of Ohio.
Pursuant to 49 U.S.C. 30118(d) and 30120(h) (see implementing rule at 49 CFR part 556), Goodyear has petitioned for an exemption from the notification and remedy requirements of 49 U.S.C. Chapter 301 on the basis that this noncompliance is inconsequential to motor vehicle safety.
This notice of receipt of Goodyear's petition is published under 49 U.S.C. 30118 and 30120 and does not represent any agency decision or other exercise of judgment concerning the merits of the petition.
Affected are approximately 26,224 Goodyear Assurance ComforTred Touring passenger car replacement tires, size 215/70R15 that were manufactured between January 4, 2010 and September 11, 2010.
NHTSA notes that the statutory provisions (49 U.S.C. 30118(d) and 30120(h)) that permit manufacturers to file petitions for a determination of inconsequentiality allow NHTSA to exempt manufacturers only from the duties found in sections 30118 and 30120, respectively, to notify owners, purchasers, and dealers of a defect or noncompliance and to remedy the defect or noncompliance. Therefore, these provisions only apply to the 26,224 tires that have already passed from the manufacturer to an owner, purchaser, or dealer.
Goodyear's petition, which was filed under 49 CFR part 556, requests an agency decision to exempt Goodyear as a replacement equipment manufacturer from the notification and recall responsibilities of 49 CFR part 573 for 26,224 of the affected tires. However, the agency cannot relieve Goodyear distributors of the prohibitions on the sale, offer for sale, or introduction or delivery for introduction into interstate commerce of the noncompliant tires under their control after Goodyear recognized that the subject noncompliance existed. Those tires must be brought into conformance, exported, or destroyed.
Paragraph S5.5(e) of FMVSS No. 139 require in pertinent part:
S5.5 Tire markings. Except as specified in paragraphs (a) through (i) of S5.5, each tire must be marked on each sidewall with the information specified in S5.5(a) through (d) and on one sidewall with the information specified in S5.5(e) through (i) according to the phase-in schedule specified in S7 of this standard. The markings must be placed between the maximum section width and the bead on at least one sidewall, unless the maximum section width of the tire is located in an area that is not more than one-fourth of the distance from the bead to the shoulder of the tire. If the maximum section width falls within that area, those markings must appear between the bead and a point one-half the distance from the bead to the shoulder of the tire, on at least one sidewall. The markings must be in letters and numerals not less than 0.078 inches high and raised above or sunk below the tire surface not less than 0.015 inches * * *
(e) The generic name of each cord material used in the plies (both side-wall and tread area) of the tire; * * *
Goodyear explains that the noncompliance is that, due to a mold labeling error, the sidewall marking on the reference side of the tires incorrectly describes the generic name of the cord material in the tread area of the tires as required by paragraph S5.5(e). Specifically, the tires in question were inadvertently manufactured with “Tread: 1 Polyester Cord + 2 Steel Cords + 1 Polyester Cord. The labeling should have been “Tread: 1 Polyester Cord + 2 Steel Cords + 1 Nylon Cord.”
Goodyear argues that this noncompliance is inconsequential to motor vehicle safety because while the non-compliant tires are mislabeled they meet or exceed all applicable Federal Motor Vehicle Safety Standards, the noncompliant sidewall marking does not create an unsafe condition, and all other labeling requirements have been met.
Goodyear points out that NHTSA has previously granted similar petitions for non-compliances in sidewall marking.
Goodyear additionally states that it has corrected the affected tire molds and all future production will have the correct material shown on the sidewall.
In summation, Goodyear believes that the described noncompliance of its tires to meet the requirements of FMVSS No. 139 is inconsequential to motor vehicle safety, and that its petition, to exempt from providing recall notification of noncompliance as required by 49 U.S.C. 30118 and remedying the recall noncompliance as required by 49 U.S.C. 30120, and should be granted.
Interested persons are invited to submit written data, views, and arguments on this petition. Comments must refer to the docket and notice number cited at the beginning of this notice and be submitted by any of the following methods:
a. By mail addressed to: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC 20590.
b. By hand delivery to U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC 20590. The Docket Section is open on weekdays from 10 a.m. to 5 p.m. except Federal Holidays.
c. Electronically: by logging onto the Federal Docket Management System (FDMS) Web site at http://www.regulations.gov/. Follow the online instructions for submitting comments. Comments may also be faxed to 1-202-493-2251.
Comments must be written in the English language, and be no greater than 15 pages in length, although there is no limit to the length of necessary attachments to the comments. If comments are submitted in hard copy form, please ensure that two copies are provided. If you wish to receive confirmation that your comments were received, please enclose a stamped, self-addressed postcard with the comments. Note that all comments received will be posted without change to http://www.regulations.gov,, including any personal information provided.
Documents submitted to a docket may be viewed by anyone at the address and times given above. The documents may also be viewed on the Internet at http://www.regulations.gov by following the online instructions for accessing the dockets. DOT's complete Privacy Act Statement is available for review in the Federal Register published on April 11, 2000, (65 FR 19477-78).
The petition, supporting materials, and all comments received before the close of business on the closing date indicated below will be filed and will be considered. All comments and supporting materials received after the closing date will also be filed and will be considered to the extent possible. When the petition is granted or denied, notice of the decision will be published in the Federal Register pursuant to the authority indicated below.
Comment closing date: April 18, 2011.
Authority: 49 U.S.C. 30118, 30120: delegations of authority at CFR 1.50 and 501.8.
Issued on: March 14, 2011.
Claude H. Harris,
Acting Associate Administrator for Enforcement.
[FR Doc. 2011-6380 Filed 3-17-11; 8:45 am]
BILLING CODE 4910-59-P