Energy Conservation Program for Consumer Products Representative Average Unit Costs of Energy

AGENCY:

Office of Energy Efficiency and Renewable Energy, Department of Energy.

ACTION:

Notice.

SUMMARY:

In this notice, the Department of Energy (DOE or Department) is forecasting the representative average unit costs of five residential energy sources for the year 2002. The five sources are electricity, natural gas, No. 2 heating oil, propane, and kerosene. The representative unit costs of these energy sources are used in the Energy Conservation Program for Consumer Products, established by Part B of Title III of the Energy Policy and Conservation Act.

EFFECTIVE DATE:

The representative average unit costs of energy contained in this notice will become effective May 24, 2002 and will remain in effect until further notice.

FOR FURTHER INFORMATION CONTACT:

Brian Card, U.S. Department of Energy, Office of Energy Efficiency and Renewable Energy, Forrestal Building, Mail Station EE-41, 1000 Independence Avenue, SW., Washington, DC 20585-0121, (202) 586-9228.

Francine Pinto, Esq., U.S. Department of Energy, Office of General Counsel, Forrestal Building, Mail Station GC-72, 1000 Independence Avenue, SW., Washington, DC 20585-0103, (202) 586-9507.

SUPPLEMENTARY INFORMATION:

Section 323 of the EPCA (Act) requires that DOE prescribe test procedures for the determination of the estimated annual operating costs or other measures of energy consumption for certain consumer products specified in the Act. These test procedures are found in 10 CFR part 430, subpart B.

Section 323(b) of the Act requires that the estimated annual operating costs of a covered product be calculated from measurements of energy use in a representative average use cycle or period of use and from representative average unit costs of the energy needed to operate such product during such cycle. The section further requires that DOE provide information to manufacturers regarding the representative average unit costs of energy. This cost information should be used by manufacturers to meet the obligations under section 323(c) of the Act. Most notably, these costs are used to comply with Federal Trade Commission (FTC) requirements for labeling. Manufacturers are required to use the revised DOE representative average unit costs when the FTC publishes new ranges of comparability for specific covered products, 16 CFR Part 305. Interested parties can also find information covering the FTC labeling requirements at www.ftc.gov/appliances.

The Department last published representative average unit costs of residential energy for use in the Energy Conservation Program for Consumer Products Other Than Automobiles on March 8, 2001 (66 FR 13917). Effective May 24, 2002, the cost figures published on March 8, 2001, will be superseded by the cost figures set forth in this notice.

The Department's Energy Information Administration (EIA) has developed the 2002 representative average unit after-tax costs of electricity, natural gas, No. 2 heating oil, propane, and kerosene prices found in this notice. The cost projections for heating oil, electricity, and natural gas are found in the December, 2001, EIA Short-Term Energy Outlook, DOE/EIA-0226 (01/12), and reflect the mid-price scenario. Projections for residential propane and kerosene prices are derived from their relative prices to that of heating oil, based on 1996-2000 averages for these three fuels. The source for these price data is the September 2001, Monthly Energy Review DOE/EIA-0035(01/09). The Short-Term Energy Outlook and the Monthly Energy Review are available at the National Energy Information Center, Forrestal Building, Room 1F-048, 1000 Independence Avenue, SW., Washington, DC 20585, (202) 586-8800.

We provide the 2002 representative average unit costs in Table 1 pursuant to section 323(b)(4) of the Act, and they will become effective May 24, 2002. They will remain in effect until further notice.