Airworthiness Directives; Turbomeca S.A. Turboshaft Engines

AGENCY:

Federal Aviation Administration (FAA), DOT.

ACTION:

Notice of proposed rulemaking (NPRM).

SUMMARY:

We propose to adopt a new airworthiness directive (AD) for all Turbomeca S.A. ARRIEL 2C, 2C1, 2C2, 2S1, and 2S2 turboshaft engines with modification TU34 or TU34A installed. This proposed AD was prompted by torque conformation box (TCB) failures. This proposed AD would require inspecting the TCB for correct resistance values and removing TCBs that fail inspection before further flight. We are proposing this AD to prevent failure of the TCB which could lead to loss of engine thrust control and damage to the aircraft.

DATES:

We must receive comments on this proposed AD by January 4, 2016.

ADDRESSES:

You may send comments by any of the following methods:

• Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
• Mail: Docket Management Facility, U.S. Department of Transportation, 1200 New Jersey Avenue SE., West Building Ground Floor, Room W12-140, Washington, DC 20590-0001.
• Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
• Fax: 202-493-2251.

For service information identified in this proposed AD, contact Turbomeca S.A., 40220 Tarnos, France; phone: 33 (0)5 59 74 40 00; fax: 33 (0)5 59 74 45 15. You may view this service information at the FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA. For information on the availability of this material at the FAA, call 781-238-7125.

Examining the AD Docket

You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2015-3805; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the mandatory continuing airworthiness information (MCAI), the regulatory evaluation, any comments received, and other information. The address for the Docket Office (phone: 800-647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

FOR FURTHER INFORMATION CONTACT:

Brian Kierstead, Aerospace Engineer, Engine Certification Office, FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803; phone: 781-238-7772; fax: 781-238-7199; email: brian.kierstead@faa.gov.

SUPPLEMENTARY INFORMATION:

Comments Invited

We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2015-3805; Directorate Identifier 2015-NE-28-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD based on those comments.

We will post all comments we receive, without change, to http://www.regulations.gov,, including any personal information you provide. We will also post a report summarizing each substantive verbal contact with FAA personnel concerning this proposed AD.

Discussion

The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Community, has issued EASA AD 2015-0177, dated August 25, 2015 (referred to hereinafter as “the MCAI”), to correct an unsafe condition for the specified products. The MCAI states:

Several cases of torque conformation box (TCB) failures have been reported on engines incorporating mod TU34 or mod TU34A. Investigation concluded that these failures were caused by cracks on soldered joints of TCB resistors.

This condition, if not corrected, could lead to limited power availability in a One Engine Inoperative (OEI) case, possibly resulting in reduced control of the helicopter.

You may obtain further information by examining the MCAI in the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2015-3805.

Related Service Information Under 1 CFR Part 51

Turbomeca S.A. has issued Mandatory Service Bulletin (MSB) No. 292 72 2860, Version A, dated July 15, 2015. The MSB describes procedures for checking TCB resistance values. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section of this NPRM.

FAA's Determination and Requirements of This Proposed AD

This product has been approved by the aviation authority of France, and is approved for operation in the United States. Pursuant to our bilateral agreement with the European Community, EASA has notified us of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all information provided by EASA and determined the unsafe condition exists and is likely to exist or develop on other products of the same type design. This proposed AD would require inspecting the TCB for correct resistance values and removing TCBs that fail inspection.

Costs of Compliance

We estimate that this proposed AD affects 300 engines installed on helicopters of U.S. registry. We estimate that it would take about 1 hour to perform an inspection. We also estimate that 20% of these engines would fail the inspection and require TCB removal, which would take about 1 hour. The average labor rate is $85 per hour. Based on these figures, we estimate the cost of this proposed AD on U.S. operators to be $30,600.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify this proposed regulation:

(1) Is not a “significant regulatory action” under Executive Order 12866,

(2) Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979),

(3) Will not affect intrastate aviation in Alaska to the extent that it justifies making a regulatory distinction, and

(4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

• Air transportation
• Aircraft
• Aviation safety
• Incorporation by reference
• Safety

The Proposed Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

PART 39—AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Authority: 49 U.S.C. 106(g), 40113, 44701.

2. The FAA amends § 39.13 by adding the following new airworthiness directive (AD):

Turbomeca S.A.: Docket No. FAA-2015-3805; Directorate Identifier 2015-NE-28-AD.

(a) Comments Due Date

We must receive comments by January 4, 2016.

(b) Affected ADs

None.

(c) Applicability

This AD applies to Turbomeca S.A. ARRIEL 2C, 2C1, 2C2, 2S1, and 2S2 turboshaft engines with modification TU34 or TU34A installed.

(d) Reason

This AD was prompted by torque conformation box (TCB) failures. We are issuing this AD to prevent failure of the TCB, which could lead to loss of engine thrust control and damage to the aircraft.

(e) Actions and Compliance

Comply with this AD within the compliance times specified, unless already done.

(1) Within 600 engine flight hours (EFHs) or 6 months after the effective date of this AD, whichever occurs first, check the resistance values on the TCB. Use Accomplishment Instructions, paragraph 2.3.2 of Turbomeca S.A. Mandatory Service Bulletin (MSB) 292 72 2860, Version A, dated July 15, 2015, to do the inspection. Repeat this inspection every 600 EFHs since last inspection.

(2) Remove before further flight any TCB that fails the inspection required by paragraph (e)(1) of this AD.

(f) Alternative Methods of Compliance (AMOCs)

The Manager, Engine Certification Office, FAA, may approve AMOCs for this AD. Use the procedures found in 14 CFR 39.19 to make your request. You may email your request to: ANE-AD-AMOC@faa.gov.

(g) Related Information

(1) For more information about this AD, contact Brian Kierstead, Aerospace Engineer, Engine Certification Office, FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803; phone: 781-238-7772; fax: 781-238-7199; email: brian.kierstead@faa.gov.

(2) Refer to MCAI European Aviation Safety Agency AD 2015-0177, dated August 25, 2015, for more information. You may examine the MCAI in the AD docket on the Internet at http://www.regulations.gov by searching for and locating it in Docket No. FAA-2015-3805.

(3) Turbomeca S.A. Mandatory Service Bulletin No. 292 72 2860, Version A, dated July 15, 2015, can be obtained from Turbomeca S.A., using the contact information in paragraph (g)(4) of this proposed AD.

(4) For service information identified in this proposed AD, contact Turbomeca S.A., 40220 Tarnos, France; phone: 33 (0)5 59 74 40 00; fax: 33 (0)5 59 74 45 15.

(5) You may view this service information at the FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA. For information on the availability of this material at the FAA, call 781-238-7125.