Section R714-160-21 - Vintage Vehicles, Custom Vehicles, and Replica Vehicles(1) The following are minimum safety equipment requirements for a custom vehicle: (a) hydraulic service brakes on all wheels with current vehicle brake and stopping standards;(b) parking brake operating on at least two wheels on the same axle;(c) seat belts for all passengers and driver;(d) sealed beam or halogen headlamps;(f) turn signal lamps and switch;(g) AS-1 safety glass or Lexan; and(h) electric or vacuum windshield wiper in front of the drivers view.(2) The inspector shall issue a rejection inspection certificate when any of the above requirements are not met.(3) Exhaust systems may discharge along the side of the vehicle provided they discharge at a point behind the rear edge of the door and exhaust is directed away from the vehicle.(4) The vehicle identification for a custom vehicle shall be a number stamped on the frame of the vehicle. (a) If no such numbers exist, then the requirements as established pursuant to Rule R873-22M-15 must be followed in order to pass inspection.(5) All safety equipment of a replica vehicle shall comply with the requirements in Subsection 41-6a-1507(3).Utah Admin. Code R714-160-21
Adopted by Utah State Bulletin Number 2016-20, effective 9/27/2016Amended by Utah State Bulletin Number 2019-1, effective 12/6/2018